Not screws I had in boxes, but screws I have recovered from other projects. I did need to purchase 3 1/4"x4" lag screws for the gate.
What you need, sir, is a Lego/OpenCV based screw sorter.
Did you use the pencil as a nail?
Are you my house’s previous owner? When I had to take off the door hinges I needed to use a flathead bit, PH2 and PZ2 bit, Torx 25 bit, a 8mm socket and they even put one nail in there too.
Did they screw the nail in?
Whoever buys that house after you is going to HAAATE you.
I have to remove the fence when we leave.
This isn’t dull, we don’t come here for sickening masochism. Unless… do you plan to burn it down? That’s still not dull though.
Some of those are probably interior screws. I’d replace them if they start rusting to avoid getting rust streaks in the wood, if that matters to you. Way to reuse/recycle!
The fence is 9 years old, and I am in New Mexico, so it is not a huge deal. That said, I only used very few interior screws.
THE SCREWS DON’T MATCH AND ARE ALSO NOT ALL FINISHED TO 90 DEGREES REEEEEEE
And I left the nails in the boards.
You’re a monster!
I did not have my hammer with me.
With the price of a screw these days, I don’t blame you.
The 4" lag screws I had to buy were 95¢ each.
Wow.
Will you go back and screw them all the way down?
If needed.
torqued out Phillips is like a comfort food
Almost all of them are T25 torx.
